LED SEMICONDUCTOR INFORMATION DEVICE СПИУ11А-8K, 8Ж, 4L
09 january 2017, 04:43
СПИУ11А-8K 8Ж 4L - Led information of the semiconductor device
Led semiconductor information device СПИУ11А-8K 8Ж 4L further light is used to replace incandescent bulbs in the scoreboard light signal type TSS-66M and made the red yellow green glow. Structurally, the circuit Board indication've put together of the led emitters mounted in a plastic reflector and controller Board is connected by two wires.
On the PCB of the controller is the circuit which implements the function diagram cell Board alarm unit TSS-66M. The circuit controller provides the mode of the health check Board display when applying a positive potential on bus bulb check SPL. When the contact signal on CSR on the object, the controller generates the current pulse value is not less than 70 mA with a duration of 0.5-1.2 seconds for the relay pulsed signaling type RESRT. Electronic ballast used to reduce the power consumption provides the illumination of the led emitters and the control circuit stops the signal from flashing emitters and transfer them to a smooth glow when applied to the tire removal flashing ShSM positive potential from the external button eat flashing CM.
The backlight has a built-in generator flashing and does not require connection to the bus flashing CMM.
The use of this class of led emitters is focused on the replacement of incandescent bulbs used in block shields of nuclear power plants on power on control panels and dashboards in circuits with relay type RESRT.
Compared to the traditionally used incandescent bulbs with led backlight have longer life span 50,000 hours vs 2000 for incandescent lamps and low temperature heating.
Operating temperature range from - 10° to + 55° C.
Led semiconductor information devices retain the performance when changing the supply voltage in the range from -15% to + 10% from the nominal value.
Can be used in alarm circuits do not require the pulsing relay.
The use of led scoreboard with electronic ballasts and electronic single vibrators for start-up relay type RESRT allows
- to improve the aesthetic and ergonomic qualities of the light display
- increase the service life of lighting fittings control panels
- to reduce the consumed means of displaying information, the power from batteries or rectifier unit in order
to increase the reliability of the activation current relay type FIG RTD
- increase the maximum number of input signals, working on one impulse the relay at least in 2 times from 30 to 60 - 70
- remove the problem of shortage of filament lamps
- to provide uniform illumination of the working surface of a Board
to increase the reliability
is to provide the ability to connect to multiple RESRT.
Table of compliance of the conclusions of the controller Board to the contacts on the connector RP 10-11
The connection is made in accordance with the marking on the PCB.
Wiring diagram of the circuits of control panels alarm is completely analogous to the connection of the TSS units with incandescent lamps and requires no changes.
PL - bus bulb check
CSR - plus power from the object
-U - negative supply
RICE - exit to RESRT
KSM - eat flashing.
The plastic reflector is mounted in a frame unit according to the TSB figure
Table of parameters and technical characteristics of the manufacture of led semiconductor devices, information SPI
Save as PDF
Save as image
POWER SUPPLY LED STRIP
POWER ADAPTERS EXTERNAL
5050 SMD LED FLEXIBLE STRIP
3528 SMD LED FLEXIBLE STRIP
OUTDOOR INFRARED HEATERS
INFRARED HEATERS CONVECTION ACTION
THE CAR HEATERS - CAR-12
ELECTRIC HEATING PLASTERBOARD PANELS - READ MORE
ELECTRIC HEATING PLASTERBOARD PANELS
SHOP INDUSTRIAL INFRARED HEATERS - ARGN
THERMOSTATS - THERMOSTATS
CEILING INFRARED HEATERS - ARGN
WALL INFRARED HEATERS - ARGN
The LIGHTING of the LED LAMP LPO-10 or LBD-1
A BARRAGE OF LOW INTENSITY ZOOM-PP, ANGRY, AIA
A BARRAGE OF LOW INTENSITY ZOOM-PPM
A BARRAGE OF LOW INTENSITY ZOOM-WEP
A BARRAGE OF LOW INTENSITY ZOOM
LED IS A SEMICONDUCTOR DEVICE INFORMATION, SPIU
LED SEMICONDUCTOR INFORMATION DEVICE СПИУ12А-8K, 8Ж, 4L or СПИУ12Б-8K, 8Ж, 4L
LED SEMICONDUCTOR INFORMATION DEVICE СПИУ10А-8K, 8Ж, 4L or СПИУ9Б-8K, 8Ж, 4L
LED SEMICONDUCTOR INFORMATION DEVICE СПИУ9А-8K, 8Ж, 4L or СПИУ9Б-8K, 8Ж, 4L
LED SEMICONDUCTOR INFORMATION DEVICE СПИУ7А-8K, 8Ж, 4L
LED SEMICONDUCTOR INFORMATION DEVICE СПИУ6А-8K, 8Ж, 4L
LED SEMICONDUCTOR INFORMATION DEVICE СПИУ5А-8K, 8Ж, 4L
LED SEMICONDUCTOR INFORMATION DEVICE СПИУ4А-2K, 2G, 1L
LED SEMICONDUCTOR INFORMATION DEVICE СПИУ3А-2K, 2G, 1L
LED SEMICONDUCTOR INFORMATION DEVICE СПИУ2А-8K, 8Ж, 4L
LED SEMICONDUCTOR INFORMATION DEVICE СПИУ1А-8K, 8Ж, 4L
LED SEMICONDUCTOR INFORMATION DEVICE SPI
CURRENT SOLID STATE LED INDICATORS, CIPM, CIPD
LED INDICATORS - CIPM, CIPD
LED LIGHT BULB - UPS-3 LIGHTHOUSE
LED IS A SEMICONDUCTOR DEVICE, LAMP-INDICATOR - OOPS-2A METEOR
LED IS A SEMICONDUCTOR DEVICE, LAMP-INDICATOR - OOPS-1A COMET
LED BULB - oops - "Comet", "meteor", "lighthouse"
LED SWITCHBOARD LAMP SKL-16
LED SWITCHBOARD LAMP SKL-15
LED SWITCHBOARD LAMP SKL-14
LED SWITCHBOARD LAMP SKL-12
LED SWITCHBOARD LAMP SKL-11
LED SWITCHBOARD LAMP SKL-10
LED SWITCHBOARD LAMP SKL-9
LED SWITCHBOARD LAMP SKL-8
LED SWITCHBOARD LAMP SKL-7